XBL Tools

Tools for manipulating Qualcomm XBL images.

unpackxbl

This tool uses brute-force and heuristics to split a Qualcomm XBL partition image into it's three respective parts.

sbl1.elf
xbl_core.elf
xbl_sec.mbn

The components

sbl1

sbl1 is the pre-loader responsible for loading everything else, it does some basic hw init, DDR training, and loads tz, hyp, abl, and other images from storage. Then it jumps to xbl_core via the hypervisor.

xbl_core

This is the actual EDKII based UEFI bootloader, when people refer to Qualcomm "XBL" they usually just mean this part. It receives some data from sbl1 which includes the address of where ABL was loaded. ABL is just a single .efi executable (LinuxLoader.efi which contains the actual Android boot image handling and fastboot implementation). It's wrapped in an EFI Firmware Volume (FV) with an ELF header appended. On Android/IoT configurations XBL will always launch LinuxLoader.efi.

xbl_sec

This binary is validated separetely to the rest of XBL, it is also the first code to run. It initialises EL3 before jumping to the pre-loader. The entrypoint of xbl.elf is actually for xbl_sec.

Why?

By being able to unpack and existing XBL image, we can then re-pack it again using the createxbl.py tool which is readily available in the coreboot repo.

Now, leveraging what we know about the structure of these ELF files, we can provide a drop-in replacement for xbl_core, namely: U-Boot. We can build U-Boot with the correct TEXT_BASE, have it generate an ELF file and then build a new XBL image which will boot directly into U-Boot instead of into EDKII.

On my device?

Unfortunately, re-generating the XBL image necessarily means re-generating the hash and re-signing it. If your device is unfused (doesn't have Qualcomm secureboot enabled), and signing images using qtestsign works for you, then you can give this approach a try. Outside of development boards and engineering samples, the only devices using XBL without secureboot that I'm aware of are the SHIFT6mq and TCL Book 14 Go.

Building

meson setup build
meson compile -C build

Using

./build/unpackxbl /path/to/stock/xbl.elf

One can then build a new XBL image with (for example) U-Boot as the payload by using createxbl.py from coreboot. This is known to work for SDM845, but other SoCs may have some issues with the MBN header and certs as generated by coreboot's createxbl.py. Running with --no_hash and using a different tool to generate the header is recommended.

../coreboot/utils/qualcomm/createxbl.py -f ./sbl1.elf -s u-boot.elf -x ./xbl_sec.mbn -a 64 -b 64 -d 64 --mbn_version=5 -o uboot1st.elf
fastboot flash xbl uboot1st.elf reboot

linux-msm/xbltools