ros2_donkey_car

ROS2 node for controlling PWM boards based on the PCA9685 chip with an I²C interface. Primary use is for controlling RC Servos and DC motors via PWM. This is based on ros-i2cpwmboard (OUTDATED) with updates to make it work on ROS2.

Update

When you launch the program, you can now choose your I²C bus. Here's an example:

ros2 run i2c_pwm_board controller 7 # The "7" tells the program to open the i2c-1/ bus, but you can change it to your desired bus.

This will be particularly useful for opening several buses between programs, and for easily adapting to the RPi Zero, which has an i2c-0/ bus by default.

Examples

# Setting PWM frequency to 50Hz.
ros2 service call /set_pwm_frequency i2c_pwm_board_msgs/srv/IntValue "{value: 50}"

# Configuring two servos.
ros2 service call /config_servos i2c_pwm_board_msgs/srv/ServosConfig "servos: [{servo: 1, center: 127, range: 100, direction: -1},{servo: 2, center: 336, range: 108, direction: 1}]"

# Configuring those two servos on differential mode.
ros2 service call /config_drive_mode i2c_pwm_board_msgs/srv/DriveMode "{mode: differential, rpm: 56.0, radius: 0.0055, track: 0.015, scale: 1.0,servos: [{servo: 1, position: 1}, {servo: 2, position: 2}]}"

# Drive both servos forward using proportional value between [-1; 1].
ros2 topic pub -1 /servos_proportional i2c_pwm_board_msgs/msg/ServoArray "{servos:[{servo: 1, value: 0.40}, {servo: 2, value: 0.40}]}"

# More documentation at the original page of the project (for ROS1) -> https://github.com/mentor-dyun/ros-i2cpwmboard/tree/master/doc or https://gitlab.com/fmrico/ros-i2cpwmboard/-/tree/master/doc

Installation

You need to have ROS2 installed (of course) and these packages provided by the default desktop installation below :

rclcpp, std_msgs, std_srvs, geometry_msgs
rosidl_default_generators, rosidl_default_runtime
Have python3-colcon-common-extensions installed
Have libi2c-dev and i2c-tools installed
Have the xmlrpcpp package

Clone it

You can clone and run this package by copying the command below :

Note that if you want to run this project, you have to clone the xmlrpcpp packages :

Testing I²C

Now when you log in you can type the following command to see all the connected devices

sudo i2cdetect -y -r 7 # Or 1, depends on the device you use.

Install automatically

You can install the i2c library and colcon by running the install scripts located at install_scripts/install_dependencies.sh. Simply just copy & paste this code :

cd install_script/
chmod +x install_dependencies.sh
sudo ./install_dependencies.sh

Build it

source /opt/ros/humble/setup.bash # With Debian binaries 
cd /i2c_pwm_board/
colcon build --packages-select i2c_pwm_board i2c_pwm_board_msgs xmlrpcpp
source install/setup.bash # Do not change directory

linuxchunk/ros2_donkey_car