Runs on LilyGo T5 V2.3 2.13 inch EPD dev board.
Developed using PlatformIO IDE.
The information on the EPD is updated once every 10 minutes. The battery voltage is shown on the bottom right corner.
- Install VSCode and PlatformIO extension
- Clone this repo
- Create a
definitions.h
file under./src
which definesWIFI_SSID
,WIFI_PASSWORD
andNEUID
(see example below) - Done 🍺🍺🍺
Example of definitions.h
:
// src/definitions.h
#define WIFI_SSID "wireless@163"
#define WIFI_PASSWORD "password@163"
#define NEUID "32953014"
- The STL files used are NewCase.STL and Cover.STL.
- The models are not optimized for FDM printing so it is better to use an SLA printer.
- The one shown in the picture above was printed with resin.