# Rubin Observatory build of the community edition of OpenSplice DDS. It is the version currently used by Rubin Observatory developers. OpenSpliceDDS directory contains the HDE for versions 6.9.0 An environment variable, OSPL_HOME, must point to the subdirectory: ./OpenSpliceDDS/V6.9.0/HDE/x86_64.linux If this package is set up with eups, this environment variable is automatically set. Note that there are firewall rules that must be modified to use DDS/Opensplice. These changes to the firewall should only need to occur once, and thus are not part of the eups installation or setup. Please see $TS_SAL_DIR/SAL_User_Guide.pdf for instructions on the firewall setup (section 1 and most of section 2). If you wish to support running more than one simulation at a time, the port range specified in the manual needs to be extended to accommodate this. The lowest port number is always 7400. To figure out the highest port number necessary, use this formula: ```7413 + (14 * (Njobs - 1))```