lucysrausch/hoverboard-firmware-hack

Extract one channel.

Kambodia91 opened this issue · 3 comments

Kambodia91 commented

hello, I have a hover board with two separate bldc control boards, I soldered stm32f103CBT6 48pin on them. Is it possible to extract the foc control for the bldc controller, e.g. via usart? The circuit is equipped with current measurement on two phases, voltage measurement and main current measurement. I also have a pinout of how the stm32 is connected
STM32-Master
STM32-Slave
both boards are connected by usart0 PA2 and PA3.

Kambodia91 commented

I know about you. but this software is not compatible with my stm32 version. in platform.ini the stm32f103RC processor is declared, it is a processor with 64 pin outputs. I have stm32f103CB in 48pin outputs. Is there anyone who can extract the code for only one motor / controller? Regards.