This repository contains the Vivado and PetaLinux projects required to use the Zynq EBAZ4205 Board.
- Zynq EBAZ4205 Board (cost-reduced version)
- No 25MHz crystal (Y3) is required. The Ethernet transceiver (U24) clock is supplied by the ZYNQ (U31). However, it also works on a board on which a crystal is mounted
- microSD card slot (U7) required
- SD card boot support is required. Short the resistor (R2577)
- Short the diode (D24) to supply power from the power connector (J4) (Optional)
- Mount the tactile switch (S3), the capacitor (C2410) and the resistor (R2641A). The resistor (R2641A) can be shorted instead of mounting a 0 ohm resistor. I used 4.7uF for the capacitor (C2410) (Optional)
- Xilinx Vivado 2021.2
- Xilinx PetaLinux 2021.2
- xjtuecho/EBAZ4205: A 5$ Xilinx ZYNQ development board.
- First setup
- Schematics
- Xilinx Design Constraints
- mtd information
- Leungfung/ebaz4205_hw
- Document (Block desgin)
- kan573 - Qiita
- Articles in Japanese
- blkf2016/ebaz4205: Some resources for the ebaz4205 board
- Sample project
- nightseas/ebit_z7010: The base reference design for EBIT EBAZ4205 Zynq7010 board.
- Sample project
- UG585 - Zynq-7000 SoC Technical Reference Manual (v1.12.2)
- UG585 - Zynq-7000 SoC テクニカル リファレンス マニュアル (v1.10)
- UG865 - Zynq-7000 SoC Packaging Guide (v1.8.1)
- UG865 - Zynq‐7000 SoC パッケージ ガイド (v1.8.1)
- XC7Z010CLG400 ピン配置ファイル
- UG1144 - PetaLinux Tools Documentation Reference Guide (v2021.2)
- LEDS-GPIO Driver - Linux GPIO Driver - Xilinx Wiki - Confluence
- GPIO-Keys Driver - Linux GPIO Driver - Xilinx Wiki - Confluence
- Vitis Tutorials 2021.1 - Vitis Platform Creation Tutorials
- Vitis チュートリアル - Vitis プラットフォームの作成チュートリアル
- LEDs connected to GPIO lines
- Common leds properties
- Device-Tree bindings for input/keyboard/gpio_keys.c keyboard driver
- Vivadoでプロジェクトのエクスポートを極める - Qiita
- MII通信 ～MACとPHYをつなぐインターフェース～ - 半導体事業 - マクニカ
- ARM PrimeCell Static Memory Controller (PL350 series) Revision: r2p1 Technical Reference Manual
- Winbond W29N01HVxINA Datasheet
- MIT