Show your memcache key usage in realtime.
This was originally inspired by mctop from etsy. I found that under load mctop would drop between 50 and 75 percent of packets. Under the same load memkeys will typically drop less than 3 percent of packets. This is on a machine saturating a 1Gb network link.
Build Status:
Usage: memkeys -i NIC [options]
-d, --discard=THRESH Discard keys where req/s rate is below THRESH
-i, --interface=NIC Network interface to capture traffic on (required)
-p, --port=PORT Network port to capture memcache traffic on (default 11211)
-r, --refresh=INTERVAL Refresh the stats display every INTERVAL ms (default 500)
-l, --logfile=FILE Output logs to FILE
-R, --report=REPORT Output data in REPORT format (CSV or curses, default curses)
-h, --help This help
-v, --verbose Increase verbosity. May be used multiple times.
-V, --version Show program info and exit.
You will most likely want to run with something like:
memkeys -i eth0 -l /tmp/memkeys.log
If you are running memkeys on a very high traffic machine you will want to specify a discard threshold, otherwise the memory footprint will grow quite large.
memkeys -i eth0 -d 10.0 -l /tmp/memkeys.log
If you are running memkeys on a proxy you may want to use -i lo to listen on
localhost.
Build is based on autoconf.
Install gperftools and gperftools-devel if you want to build with
--enable-profiling. You will typically want to configure with
--enable-debug, and possibly with --enable-development. The latter two
options will enable additional error logging. If you are actually doing
development you should definitely add --enable-development as doing so will
add some additional compiler flags to help catch errors.
You will need libpcap-devel, libpcrecpp, and libncurses-devel.
On Ubuntu with all packages:
sudo apt-get install autoconf libpcap-dev libpcre3-dev libncurses5-dev:i386 google-perftools libgoogle-perftools-dev
./build-eng/autogen.sh
make
make check
Substitute lib32ncurses5-dev for libncurses5-dev:i386 on 32-bit machines.
memkeys was developed on CentOS 5.8 with the following software tools:
GCC version : g++44 (GCC) 4.4.6 20110731 (Red Hat 4.4.6-3)
GNU gmake : 3.81
ld : 2.17.50.0.6-20
coreutils : 5.97
libtool : 2.4.2
autoconf : 2.68
automake : 1.9.6
The following library versions were used:
libpcap-devel : 0.9.4-15
pcre-devel : 6.6-6
ncurses-devel : 5.5-24.20060715
This should build fine against newer versions of the above tools. Different libraries are untested.
Copyright 2013 Tumblr.
Licensed under the Apache License, Version 2.0 (the "License"); you may not use this file except in compliance with the License. You may obtain a copy of the License at http://www.apache.org/licenses/LICENSE-2.0
Unless required by applicable law or agreed to in writing, software distributed under the License is distributed on an "AS IS" BASIS, WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the License for the specific language governing permissions and limitations under the License.