read value 0
zainurihasan opened this issue · 3 comments
i use the example & wemos d1 mini pro
after testing the example code, it only shows voltage & frequency, and other data is 0
here is serial monitor log:
Custom Address:1
Voltage: 227.90V
Current: 0.00A
Power: 0.00W
Energy: 0.000kWh
Frequency: 50.0Hz
PF: 0.00
can anyone help me?
Looks like you are not drawing any power or the current transformer isn't attached properly. Make sure to have the current transformer attached on ONE of the TWO wires (Important to only put ONE of the power wires through the Current transformer hole. Either the Live or the Neutral but NOT BOTH). And then make sure the device is drawing some power.
Looks like you are not drawing any power or the current transformer isn't attached properly. Make sure to have the current transformer attached on ONE of the TWO wires (Importatnt to only put ONE of the power wires through the Current transformer hole. Either the Live or the Neutral but NOT BOTH). And then make sure the device is drawing some power.
Has your issue been resolved? If so please kindly close this issue. Thanks :)