This is a Home Assistant Add-on that runs PrusaSlicer on a Debian container and exposes the GUI via NoVNC as a webpage. Based on helfrichmichael/prusaslicer-novnc and Poeschl's vnc-viewer add-on
The installation of this add-on is pretty straightforward and not different in comparison to installing any other Home Assistant add-on.
- Add our Home Assistant add-ons repository to your Home Assistant instance.
- Install the "PrusaSlicer NoVNC" add-on.
- Check the "Show in sidebar toggle.
- Start the "PrusaSlicer NoVNC" add-on
- Check the logs of the "PrusaSlicer NoVNC" add-on to see if everything went well.
- Open the "PrusaSlicer" tab on Home Assistant.
📚 Read the full add-on documentation
NOTE: Starting the add-on might take a couple of minutes (especially the first time starting the add-on).
NOTE: Do not add this repository to Home Assistant, please use:
https://github.com/marciogranzotto/addons-repository.
Got questions?
You can open an issue here on GitHub.
This is an active open-source project. We are always open to people who want to use the code or contribute to it.
Thank you for being involved! 😍
The original setup of this repository is by Marcio Granzotto.
For a full list of all authors and contributors, check the contributor's page.
GNU GENERAL PUBLIC LICENSE Version 3, 29 June 2007
Copyright (C) 2007 Free Software Foundation, Inc. https://fsf.org/ Everyone is permitted to copy and distribute verbatim copies of this license document, but changing it is not allowed.