Trouble Adding BD Sensor to Ender 3 Pro with SKR PRO V1.2
Closed this issue · 7 comments
Struggling to figure out what I'm doing wrong, I feel like I'm so close
Compiling Marlin 2.1.x-bugfix (current as of a few days ago)
Everything is connected correctly (LED on BD Sensor behaves properly when close to metal)
M102 doesn't return as expected (no mention of V1.0 pandapi3d.com):
>>> M102 S-1
SENDING:M102 S-1
ok P15 B3
M119 behaves oddly. z_min changes from open to TRIGGERED, but z_probe is always set to triggered (I would expect probe to change and z_min to always stay the same)
SENDING:M119
Reporting endstop status
x_min: open
y_min: open
z_min: open
z_probe: TRIGGERED
M102 S-6 behaves correctly and calibrates, M102 S-5 reads back the calibration curve
Board is a BTT SRK PRO V1.2 (pinouts https://github.com/bigtreetech/BIGTREETECH-SKR-PRO-V1.1/blob/master/SKR-PRO-V1.2/manual/SKR-PRO-V1.2PIN.PDF)
I've set the following pins (used to have a BL Touch installed, so the BD Sensor is just using the same connection on the hotend)
#ifndef I2C_BD_SDA_PIN
#define I2C_BD_SDA_PIN PA2
#endif
#ifndef I2C_BD_SCL_PIN
#define I2C_BD_SCL_PIN PA1
#endif
#ifndef I2C_BD_DELAY
#define I2C_BD_DELAY 20
#endif
Not sure why M102 S-1 isn't responding and z-probe isn't updating correctly. Any ideas?
for testing, you can then try to connect to the EXP1, for example LCD_D7_PG7 and LCD_D7_PG6 for the SDA and SCL
for testing, you can then try to connect to the EXP1, for example LCD_D7_PG7 and LCD_D7_PG6 for the SDA and SCL
same behaviour (z_min changes state instead of z_probe) on PG7 and PG6 (EXP1 ports suggested for this board). I'm wondering if it's a weird Marlin issue, going to try a different version of the bugfix branch and see if that resolves it.
did you enable the USE_PROBE_FOR_Z_HOMING ?
//#define Z_MIN_PROBE_USES_Z_MIN_ENDSTOP_PIN
// Force the use of the probe for Z-axis homing
#define USE_PROBE_FOR_Z_HOMING
and you can this firmware that I pulled to official marlin recently.
https://github.com/markniu/MarlinPULL/tree/bugfix-2.1.x
MarlinFirmware/Marlin#27243
Yep, I have using the endstop commented out and use probe for homing
I'll give your fork a shot! Does it also support nozzle collision sensing for Marlin?
the code on my github supports the collision sensing.
Great! I just tried a quick build with your fork and m102 S-1 correctly reports
ok P15 B3
BD Sensor version:V1.2c pandapi3d
,sw_mode:1
Which seems better than I had before. Now I just need to redo my configurations for this version. Thanks!