TH16ermostat

Homebridge plugin for Sonoff TH16/TH10

This is a simple accessory plugin to control Sonoff TH16/TH10 with thermal probe (DS18B20, SI7021, others) like a thermostat. Humidity sensors are supported and can be enabled or disabled. Use on you own risk and be patient.

Prerequisities

Tasmotized Sonoff TH16/TH10. Google for "Sonoff TH16 Tasmota" if you still use original firmware (eWeLink app).

Installation

Install homebridge using: [sudo] npm install -g homebridge
Install this plugin using: [sudo] npm install -g homebridge-th16ermostat
Update your configuration file, at least the IP address of TH16/TH10 device. See the sample below.

Configuration

Add the following information to your config file in "accessories" section: Only required values are "accessory", "name", "sensorName" and "deviceIPAddress". Values shown are used as default values.

Note: If if fails to start/initialize after installing and configuring through homebridge, check the config. It might have different accessory identifier, e.g. 'homebridge-th16ermostat' instead of 'TH16ermostat'. Also 'name' and 'sensorName' cannot be missing. As 'sensorName' use the name of your probe. You can see it in the output of http://x.x.x.x/cm?cmnd=status%208, for example 'DS18B20' (put your Tasmota IP address instead of x.x.x.x)

    "accessories": [
        {
            "accessory": "TH16ermostat",
            "name": "Kitchen Infra Heater",
            "sensorName": "DS18B20",
            "deviceIPAddress": "",

            "enableHumidity": false,
            "minTemp": -25,
            "maxTemp": 40,
            "stepTemp": 0.5,
            "deltaTemp": 0.2,
            "pollingInterval": 60,
            "deviceStatStatus": "/cm?cmnd=status%208",
            "deviceStatPower": "/cm?cmnd=power",
            "deviceCmndOn": "/cm?cmnd=power%20on",
            "deviceCmndOff": "/cm?cmnd=power%20off"
        },
    ],

Description of settings