ReplaySorcery

An open-source, instant-replay solution for Linux.

Back when I used to use windows I used AMD ReLive alot. It, and the nVidia version ShadowPlay Instant Replay, will constantly record the screen without using too much computer resources and at the press of a keycombo will save the last 30 seconds.

I wanted something like this for Linux...

I got tired waiting for someone else to do it.

Documentation

Installing
- Arch
Building from Source
- Required Dependencies
- Optional Dependencies
Running
Configuration
Hardware Acceleration
- Using replay-sorcery-kms
- nVidia Support
Wayland Support

Installing

Arch

There is an official AUR package that gets updated from the CI (thanks to Bennett Hardwick): replay-sorcery.

Sergey A. has also setup a -git AUR package: replay-sorcery-git.

Building from Source

$ git submodule update --init
$ cmake -B bin -DCMAKE_BUILD_TYPE=Release
$ make -C bin
$ sudo make -C bin install

Required dependencies

CMake
FFmpeg

Optional dependencies

Xlib and xcb (for software screen recording and keyboard shortcuts on X11)
PulseAudio (for audio recording)
libdrm (for listing kms devices)

Running

It can be enabled as a user systemd service:

$ systemctl --user enable --now replay-sorcery

Once it is running, just press Ctrl+Super+R to save the last 30 seconds.

When the configuration file has changed, the service must be reloaded by running:

$ systemctl --user restart replay-sorcery

You can also use systemd to look at the output:

$ journalctl --user -fu replay-sorcery

Configuration

The config file location and options has completely changed since version 0.3.x

There are two config files:

The global config file is located at @CMAKE_INSTALL_PREFIX@/etc/replay-sorcery.conf (/usr/local/etc/replay-sorcery.conf by default).
The local config file is located at ~/.config/replay-sorcery.conf. Options in this file will overwrite options in the global file.

See sys/replay-sorcery.conf for the default values along with documentation. This file is installed into the global config file location.

Hardware Acceleration

Using `replay-sorcery-kms`

Due to hardware acceleration requiring root permissions, the recommended way of enabling hardware acceleration is by using the KMS service. Start the service by running:

$ sudo systemctl enable --now replay-sorcery-kms

Then set videoInput in the configuration file to either hwaccel or kms_service and start or restart the user service as documented above.

nVidia Support

The Nouveau open source drivers are supported but sadly the proprietary nVidia drivers do not support VA-API which is currently required for hardware acceleration. In the future NVENC might be supported. Software encoding is always supported and tries to use as little CPU as possible.

Wayland Support

Wayland screen grabbing is not currently supported, however hardware accelerated screen grabbing works fine. See above for steps for enabling that.

Wayland also does not allow listening to keyboard events unless you are the active window. To get around this you can set controller in the configuration file to command and setup a shortcut in your window manager to run:

$ replay-sorcery save

TODO

Support NVENC API
Document code better
Cross-platform support
- Doubt there is any demand though
- Maybe for Intel devices if they are fast enough?

matanui159/ReplaySorcery