Voron V2.823 Klipper Profile
Software:
Hardware:
- Raspberry Pi 4B
- Fysetc Spider V1.0 Controller Board
- TMC2209 Stepper Drivers
Mods/Deviations (W.R.T. Stock V2.4):
- Raspberry Pi uses a heatframe for efficent passive cooling.
- 12V LED Strips for chamber lighting.
- Edwardyeeks' Braced Z Drive Motor/Tensioner
- StvPtrsn's Side Fan Supports w/o Tape
- Changed controller chamber fans to be controlled (fans only operate when the drivers are active).
- Cork insulation directly under hotbed to protect electronic chamber from direct/radiated heat.
- Edwardyeeks' Purge Bucket and Nozzle cleaner
- BadNoob's AfterBurner BadNoob Version 30 (finally released/public)
- Wile-e1's Deck Panel Support Clips
- Hartk's AB Toolhead PCB
- JosAr's Klicky Probe
- ProtoLoft/TitusLabs' Z Calibration Plugin
- Hartk's GE5C Z Bearings
- Hartk's Pins Mode
- Hartk's Y Endstop Relocation
- Replaced the stock V2 X Carriage Frame w/ the stock V1.8 version (includes X endstop location).
- Phalanx' "Other" Idlers
- JaredC01's Galileo Clockwork
- Leandromarceddu's ADXL345 Galileo Mount
Updates:
- Replaced all motions parts on the gantry w/ pinned parts. Relocated X/Y Endstops.
- Rewired entire machine w/ PTFE, added Hartk's Toolhead PCB, replaced Omron Probe w/ Klicky probe.
- Added code to allow moonraker's Update Manager to pull config changes.
- Replaced 2x SKR 1.3 controllers with single Fysetc Spider.
- System operational. Additional tuning and printing of remaining parts (skirts, exhaust, etc) in progress.
- Hotbed and hotend calibrated.
- First print (PLA) and machine serialized (V2.823).
- All motors are functional. X/Y can home using the hall effect sensor.
This repo based on f0or1s' cr10_klipper repo, rpanfili's woron-ht repo, and Zellneralex's klipper_config repo among many others. It is a work in progress as I keept finding new and better ways to organize/tune my setup.