Alwas on
Closed this issue · 6 comments
TjOsT1975 commented
I get these message on config:
Please release all buttons to continue
and in retropie one tab on left and it stays on.
mholgatem commented
you'll have to give me a bit. I'm looking into the problem. I'll let you know as soon as I have a fix.
mholgatem commented
ok, do this.
cd ~/GPIOnext
wget https://raw.githubusercontent.com/mholgatem/GPIOnext/master/update.sh
git add update.sh
sudo bash update.sh
That should fix the problem
TjOsT1975 commented
Seems to work. Thank you.
… Am 12.10.2017 um 01:39 schrieb mholgatem ***@***.***>:
ok, do this.
cd ~/GPIOnext
wget https://raw.githubusercontent.com/mholgatem/GPIOnext/master/update.sh
git add update.sh
sudo bash update.sh
That should fix the problem
—
You are receiving this because you authored the thread.
Reply to this email directly, view it on GitHub <#2 (comment)>, or mute the thread <https://github.com/notifications/unsubscribe-auth/AdZl49lnoQoKXXiLiKdbculvJItvkeYIks5srVHAgaJpZM4P1pgu>.
mholgatem commented
yep. let me know if you run into any other problems!
TjOsT1975 commented
pi@retropie:~/GPIOnext $ sudo gpionext config
/usr/bin/gpionext: 6: /usr/bin/gpionext: shopt: not found
/usr/bin/gpionext: 146: /usr/bin/gpionext: [[: not found
Unrecognized Parameter: config
You can control the GPIOnext daemon using the following commands:
- gpionext start -> Enable + Start daemon
- gpionext stop -> Stop daemon until reboot or gpionext start is called
- gpionext reload -> Reload daemon
- gpionext config -> Run gpionext config
- gpionext disable -> Stop daemon/Disable auto-start on boot (type gpionext start to re-enable auto-start)
- gpionext journal -> Display any system output
- gpionext test [1-4] -> run jstest for gpionext virtual controller
-------------------------------------------------------------------------------------------------------------------------------
- gpionext set combo_delay [milliseconds] -> Delay in milliseconds to wait for additional buttons to be pressed for combos
- gpionext set debounce [milliseconds] -> Delay in milliseconds to wait to avoid multiple accidental presses
- gpionext set pins [default | pin numbers] -> default = all available pins or comma separated pin numbers (ex. 3,5,7,11,40)
- gpionext set pulldown [true | false] -> set pins to use pulldown resistors instead of pull up (excludes pins 3 + 5)
- gpionext set dev [true | false] -> output information to console while program in use (use 'gpionext journal' to view)
- gpionext set debug [true | false] -> output information to gpionext/logFile.txt
/usr/bin/gpionext: 171: /usr/bin/gpionext: shopt: not found
… Am 12.10.2017 um 17:41 schrieb mholgatem ***@***.***>:
Closed #2 <#2>.
—
You are receiving this because you authored the thread.
Reply to this email directly, view it on GitHub <#2 (comment)>, or mute the thread <https://github.com/notifications/unsubscribe-auth/AdZl4yqNkPYadzG0vQ5d_bRikSeH5NS1ks5srjNGgaJpZM4P1pgu>.
mholgatem commented
don't use sudo
it's just gpionext config