- Updated code base to latest official release (2.10.3.6 rc2)
- Updated code base to latest official release (2.10.3.6 rc1)
- Added HL2 database CLI option to shortcut
- Updated code base to latest official release (2.10.3.6 dev_8)
- Fix for non disablement of PA when disabled from xvtr form
- Added ability to select Alt Rx for transverter input in xvtr form
- Updated code base to latest official release (2.10.3.6 dev_6b)
- Fix for HL2 of Tx attenuator in official codebase
- Removed automatic renaming of database folder, the Thetis-HL2-x64 must be manually renamed to Thetis-x64
- Updated code base to latest official release (2.10.3.6 dev_4)
- Updated to allow RF off delay before releasing PTT for Tun & 2TON
- Updated to not over write txtPSpeak for PS
- Updated to handle existing database.bak
- HL2 now uses common directory for database
- Updated code base to latest official release (2.10.3.6 dev_3)
- Updated to allow ASIO on Protocol 1, YMMV
- Added missing label for auto attenuator
- Corrected reverse power calculation
- Fixed tune power slider not remembering max setting
- Updates from official repo
- Fixed custom display showing all lines at startup
- Added ability to control ICOM ATU power blip at start of tune (Setup|General|PA Control|ATU|Standalone ATU)
- Fixed issue with CL2 control when I/O Board is not fitted
- Fixed incorrect display of forward and reverse power
- Fixed incorrect noise floor on Rx2 when changing frequency
- Update I2C control to make it more robust
- Added ability to control I/O Board output port
- Fixed PS Sync option not updating on startup
- Updated with code updates to integrate with official code base
- Removed HL2 options to it's own tab within the Options tab
- Updated with latest code updates from official code base
- Updated the low level code in preparation for merger into official code base
- Fixed Minor UI updates for better skin alignment.
- Fixed Tune/Drive slider limits.
- Added Gateware patch version to title and setup display.
- Added support for register 32 for I/O Board giving current mode.
- Added extra support for ATU tuning. This is for use with the I/O Board. Thetis now reports returned errors and the power for an ATU can be controlled via the fixed drive setting.
- Added right click limits in the Drive and Tune Drive sliders.
- Fixed title display, now responses correctly to IP address tick box.
- Formal release.
- Fixed issue were using the 10Mhz input would affect I/O Board.
- Updated codebase to reflect changes added to official Thetis.
- Updated codebase to reflect changes added to official Thetis.