miblooming/JZ-TS24-2

JZ-TS40 BabbyStepping

Closed this issue · 11 comments

ffnull commented

Hello.Recently buy your display. Best controller ever. Wifi printing is awsome, but i need babbystepping to correct first layer. How i can add it or can you add it?

ffnull commented

Project abadoned? no support at all?

miblooming commented

Sorry, I am not familiar with babbystepping. I am learning about this iusse.

miblooming commented

Three methods：
1.Add some codes in Gcode file by modifing the setting "Starting G-Code" of slicer software
2.Add a button on screen by UIEditor to trigger G290-operation by handwork
https://github.com/miblooming/JZ-TS24-2/tree/master/JZHelper_ui_editor/JZ-TS35WIFI___(3.5%264.0)
https://www.youtube.com/playlist?list=PLamn4I4Ptg5KcN8KiLsWBeAiS-ABRkXjR
3.Add an event operation of by UIEditor
event_trigger20191006173618

ffnull commented

I need add it to main screen of printing process. Button must be near buttons of corrections of temperatures of heaters. on center of button must be shown real height of Z and it must be change while clicking up and down

ffnull commented

Here another example how its work https://youtu.be/s5kld8MIo6M

ffnull commented

by the way. no sizes and no models for jz-ts40.

miblooming commented

The firmware of jz-ts40 is same as jz-ts35

RV3Dtech commented

for Example:

image

image