| Device | Config |
|---|---|
| WiFi Switch V1 | Not supported, incompatible chipset. |
| WiFi Switch V2 | mystrom-switch-v2.yaml |
ESPHome support for the MyStrom V2 Wifi Switch. Currently the following features are supported
- Control the relay
- Control the red and white LED
- Side and bottom buttons (same function)
- Energy monitoring and reporting (room for improvement)
- Reading the internal temperature sensor
- Emergency power off if the internal temperature is to high
JP1
GND [] () TXD
GND () () RXD
GND () () GPIO0
GND () ()
GND () ()
VCC () ()
VCC () ()
() ()
() ()Connect a UART programmer to the WiFi Switch in the following way:
| MyStrom PIN | Programmer |
|---|---|
| GND | GND |
| VCC | 3V3 |
| TXD | TXD |
| RXD | RXD |
| GPIO0 | GND |
If you use dupont wires it may be possible to connect these without soldering.