Turnip 💡

Monitor sensors and execute actions based on their readings.

About

Turnip monitors data sources (sensors), reading values from them at user-defined intervals. It uses rules to decide what to do based on the readings.

It was initially built with temperature control in mind, but it's flexible enough to be used for any application where simple decisions need to be made based on current conditions.

Installation

TODO

Configuration

Turnip is configured via a JSON file that has the following sections:

socket: a UNIX domain socket to listen for control commands on. Used by tufwctl to interact with a running tufwd process.
sensors: an array of objects naming and configuring data sources
outputs: an array of objects naming and configuring "outputs" - e.g. GPIO pins, scripts to run, etc.
rules: an array containing rule objects describing what to do when sensors return particular values

Example Config

I use these rules to keep my graphics card in a comfy temperature range while mining ETH. If the GPU temperature is 44C or higher, Turnip decreases the maximum wattage by 10 every 2 minutes until the temperature goes back down. It does the reverse if the temp is too low.

{
  "sensors": [
    {
      "name": "gpuTemp",
      "driver": "nvidia-gpu-temp",
      "options": {
        "scale": "C"
      }
    }
  ],
  "outputs": [
    {
      "name": "gpuPower",
      "driver": "nvidia-gpu-power",
      "options": {
        "min": 160,
        "max": 230
      }
    }
  ],
  "rules": [
    {
      "threshold": 44,
      "comparison": "gte",
      "interval": "2m",
      "sensor": "gpuTemp",
      "immediate": true,
      "action": {
        "output": "gpuPower",
        "state": "-10"
      },
      "resetWhenNegative": false
    },
    {
      "threshold": 40,
      "comparison": "lte",
      "interval": "2m",
      "sensor": "gpuTemp",
      "immediate": false,
      "action": {
        "output": "gpuPower",
        "state": "+10"
      }
    }
  ]
}

Usage