modustrialmaker
I run the Modustrial Maker YouTube channel, where I document all my projects, many of which involve Arduino and LED programming.
Modustrial Maker
Pinned Repositories
Audio-Reactive-LED-Matrix
Code for 16x16 LED Matrix (WS2812) that reacts to sounds detected from an electret microphone, and switches modes with a momentary push button. Based on FastLED library, and runs best on Arduino Mega.
Kylo-Ren-Neopixel-Lightsaber-
Duplicate code - ignore
Kylo_Ren_Lightsaber_Neopixel
Kylo Ren lightsaber code for Neopixels (WS2812) using FastLED. There are 6 LED strips, 2 long ones in the main blade, and 4 short ones (strips doubled up in each blade). Since I was tight on space in the saber, I ran one control wire to the two strips in the long blade, and one control wire to the four strips in cross gaurd. I also added in a party mode with some FastLED patterns, you can switch between with a button.
Lightsaber_single_blade_neopixel
This code controls a neopixel lightsaber with an Arduino (I ran it on a nano). It has on/off effects, and slight pulsing of hue and saturation while on. It also switches to a party mode using the FastLED library for colorful patterns.
Living_Art_LED_Matrix_Lamp
This is LED matrix code for a "living art" desk lamp, that can also switch to use a normal white desk lamp or a red nightlight
Rings-of-Saturn-LED-Light-Music-Visualizer
This is the code that is used for my "Rings of Saturn" light. It is very crude code right now, and there are a couple bugs, but it works for the most part. I used an electret microphone input, and a 6-channel RF receiver with remote, connected to an Arduino Mega. I plan to port this to an ESP8266 for Wifi control at some point.
modustrialmaker's Repositories
modustrialmaker/Audio-Reactive-LED-Matrix
Code for 16x16 LED Matrix (WS2812) that reacts to sounds detected from an electret microphone, and switches modes with a momentary push button. Based on FastLED library, and runs best on Arduino Mega.
modustrialmaker/Rings-of-Saturn-LED-Light-Music-Visualizer
This is the code that is used for my "Rings of Saturn" light. It is very crude code right now, and there are a couple bugs, but it works for the most part. I used an electret microphone input, and a 6-channel RF receiver with remote, connected to an Arduino Mega. I plan to port this to an ESP8266 for Wifi control at some point.
modustrialmaker/Kylo_Ren_Lightsaber_Neopixel
Kylo Ren lightsaber code for Neopixels (WS2812) using FastLED. There are 6 LED strips, 2 long ones in the main blade, and 4 short ones (strips doubled up in each blade). Since I was tight on space in the saber, I ran one control wire to the two strips in the long blade, and one control wire to the four strips in cross gaurd. I also added in a party mode with some FastLED patterns, you can switch between with a button.
modustrialmaker/Lightsaber_single_blade_neopixel
This code controls a neopixel lightsaber with an Arduino (I ran it on a nano). It has on/off effects, and slight pulsing of hue and saturation while on. It also switches to a party mode using the FastLED library for colorful patterns.
modustrialmaker/Living_Art_LED_Matrix_Lamp
This is LED matrix code for a "living art" desk lamp, that can also switch to use a normal white desk lamp or a red nightlight
modustrialmaker/Kylo-Ren-Neopixel-Lightsaber-
Duplicate code - ignore