Z-Probe and scrubbing heads on the table.
Closed this issue · 1 comments
Does HH include Z-Probe in its calculations? Despite the disabling all the possible settings related to Z-HOP (Or I have "false" or "0") nothing changes, it is constantly scrubbing at the table.
Does anyone use HH with a MicroProbe? In the case of this sensor, the house is not set to zero but for e.g. 1.71. If MMU now reset the variable problem ready. But maybe I'm wrong. I am looking for the cause of scrubbing of the nozzle.
I found !!! After a long search, the solution turned out to be trivial.
Turn on the "use of relative values E" in the PrusaSlicer.
And I don't know why it must be turned on. I have always printed on absolute settings.
What I took for scrubbing at the table was actually an attempt to push the filament 75mm2 by Extruder. The sound is similar
:-)