sync_multiplier_low error HH v2.7.3-25
Closed this issue · 5 comments
After updating to HH v2.7.3-25-g70115862, I now receive the error:
Option 'sync_multipler_low' is not valid in section 'mmu'
In order to run, I now need to comment out the line in mmu_parameters.cfg like below in order for Klipper to start.
sync_feedback_enable: 1 # 0 = Turn off (even with fitted sensor), 1 = Turn on when printing
sync_multiplier_high: 1.05 # Maximum factor to apply to gear stepper rotation_distance
#sync_multipler_low: 0.95 # Minimum factor to apply
Ditto of above.
Check the spelling, sync_multipler_low --> sync_multiplier_low.
Good catch mrmultifunk! It appears that HH v2.7.3-25-g70115862 has a type-o in it. I'm in the middle of a print right now, but I'll fix the type-o and see if that fixes the issue appropriately.
Yes it was an typo. It is fixed now with the correct spelling. Sorry about that.
This issue is stale because it has been open for over 30 days with no activity. It will be closed in 14 days automatically unless there is activity.