ableton plug-in configure mode gives nonsensical values
Opened this issue · 0 comments
neonpixii commented
when attempting to configure/automate helm parameters outside of the helm ui itself, nonsensical values are given.
the slider in the configure section goes from 1 - 11, but numbers are not always where you'd expect, for instance, 8 is shown as being higher than 10
the value in the automation lane goes from 0.00 to 1.00 & has no correlation to either the slider readout or the actual helm parameter readout
in the following screenshots, you can see that 1/8 frequency corresponds to a 10 on the slider and a 0.73 on the lane, and a 1/32 frequency corresponds to a 8 on the slider and a 0.86 on the lane
this is using the latest version of helm & ableton 10 live lite
