/LaserSafety

Arduino code for the lasercutter safety system

Primary LanguageArduino

LaserSafety

Arduino code for the lasercutter safety system

See the control panel: http://log.munichmakerlab.de/day/2015/04/27

Sensors

  • Flowsensor FS300a
  • 2x Dallas 1Wire temperature sensors
  • 3x water sensors (open when ok)
  • diffence pressure sensor to check on vent

Programm flow

  • Interrupt driven counter to check Flowsensor
  • start Dallas Temp reading, set timeout
  • check everything else in loop
  • timeout read reached, check temp
  • if errors, stop machine, change status leds