- A UI that matches OctoPrint printer
- Client and server architecture solution
- OctoPi -> OctoPrint service -> Printer
(The update and upgrade operations are not redundant)
1. Install OctoPrint(direct use of OctoPi is recommended , Up to Octopi 0.17 is supported, and you need to go to OctoprInt's Web page to complete the initialization, need to be disable access control)-- (install under directory)
-
You can create a WPA profile in the boot directory boot/wpa_supplicant.txt to add WiFi connections
-
If you are a BX machine model user, you will need to add the following fragment lines to the RaspberryPi boot/config.txt file to display them correctly on screen:
- max_usb_current=1
- hdmi_group=2
- hdmi_mode=87
- hdmi_cvt 1024 600 60
- hdmi_drive=1
- SSH your PI on your computer for further action
After Pi boot you can get the IP address of Pi from the screen
If you connect with console
If you connect with terminal
Run Command (Installation):
- rm -f startup.sh ; wget --no-check-certificate https://raw.githubusercontent.com/bigtreetech/OctoBTT/master/startup.sh && sudo /bin/sh startup.sh
- Used with OctoPrint
- Because the serial port delay is long, the background has blocked the serial port connection, we only use the USB automatic connection
- It is recommended to run with Marlin firmware. Currently there may be some unknown problems due to non-marlin firmware
- If you want to use octoprint online , you can use the network cable to connect to the router.
- Fork the repository
- New Feat_ XXX branch
- Submit code
- New Pull Request