IBC testbed
Preparation
You'll need either wasmd or cudos-noded installed.
You'll need to install supervisor.
You'll need to install ts-relayer.
To use other node binaries, you'll need to do some editing.
Edit etc/env to select which node binary you'll be using.
Using
It probably won't work properly unless you're in the root directory of the repo.
Starting from scratch
Run bin/init.
This wipes out any existing chain data.
Stopping
Run bin/stop.
Starting again
Run bin/start.
Cleaning up
Run bin/destroy.
Other commands
Some commands require source include/env.sh first.
use-chain
use-chain N
address
address ACCOUNT_NAME
make-account
make-account NAME MNEMONIC...
ibc-transfer
ibc-transfer PORT CHANNEL RECIPIENT AMOUNT
wasm-store
wasm-store NAME WASM_FILE
cw20-create
cw20-create TOKEN NAME DECIMALS AMOUNT
Creates a new CW20 token from the cw20_base contract, which must have been stored using
wasm-store.
AMOUNT tokens are given to account0.
Operates on the current chain.
e.g.
cw20-create COIN 'CoinCoin' 2 1000000
cw20-balance
cw20-balance TOKEN [ADDRESS]
Shows the balance of the token for the address, or account0 if the address is not given.
Operates on the current chain.
cw20-info
cw20-info TOKEN
cw20-send
cw20-info TOKEN RECIPIENT AMOUNT
cw20-ics20-create
cw20-ics20-create BRIDGE
Creates a CW20-ICS20 bridge. Note it isn't connected to anything.
cw20-ics20-send
cw20-ics20-send BRIDGE TOKEN AMOUNT CHANNEL RECIPIENT