A frame for FNX-9 and FNX-40 part kits
by nguyenkvvn minor geometry referenced from the FNS940 model by TMS
The FNX is a polymer hammer-fired pistol availible in 9mm and .40 S&W. It is a precursor to the FNS series of pistols. It uses plates for rails, rather than a monolithic locking block or integrated into the fire-control housings. It is only availible commercially in full-size configuration.
Geometry that was referenced from the FNS940 model by TMS includes but is not limited to: magazine button cut-out, magazine button spring relief, trigger pin location.
You will need a set of each below for each FNX-9/40 you make.
This model is compatible with any FNX-9 or FNX-40 parts kit. It is not compatible with the FNX-45 or FNX-45 Tactical.
- x1 Parts Kit - Procure a parts kit of your preferred caliber.
- x1 Magazine - Procure a magazine of your preferred caliber
- Print with PLA+, or Tough PLA.
- Tree supports are recommended
- Print rails down on the bed
- It is imperative your printer has no elephant footing- otherwise the rail plates may not seat properly!
Assembly instructions can be found in the rich-text PDF included.
-
v1.0: Release
- Promotion to release
-
v0.4: Private Beta Candiate 4
- Revised front takedown lever clearances
- Omitted horseshoe geometry
- Refined front rail fitment geometry
-
v0.3: Private Beta Candiate 3
- Loosened tolerances for rear rail plates
- Loosened tolerances for front rail / locking block places
-
v0.2: Private Beta Candiate 2
- Added right-hand safety selector cutout
- Re-introduced some takedown-lever geometry
- Tightened tolerances for the front locking block plates
-
v0.1: Private Beta Candidate 1
- Initial commit
No license selected.