Complete project for build wireless touch display to control HomeAssistant powered SmartHome.
TNDisplay
The goal of the project is to create a wireless touchscreen display that can be programmed using NodeRed and used to control HomeAssistant powered SmartHome.
1
2
3
Requirements
Hardware
Nextion HMI Display, model NX3224T024 or other Nextion display with resolution 320x240px
Set Tasmota rule to initialize communication and show informations when connecting/disconnecting wifi and mqtt. Open tasmota console and execute following command:
Rule1 ON System#Init DO serialsend5 64696d3d313030ffffff ENDON ON Wifi#Connected DO serialsend5 706167652036ffffff54312e7478743d2257494649204f4b22ffffff50312e7069633d3237ffffff ENDON ON Wifi#Disconnected DO serialsend5 706167652036ffffff54312e7478743d2257494649204f46464c494e4522ffffff50312e7069633d3531ffffff ENDON ON Mqtt#Connected DO serialsend5 706167652036ffffff54312e7478743d224d515454204f4b22ffffff50312e7069633d3236ffffff ENDON ON Mqtt#Disconnected DO serialsend5 706167652036ffffff54312e7478743d224d515454204f46464c494e4522ffffff50312e7069633d3434ffffff ENDON
Enable Rule1 by executing command:
Rule1 1
Connect ESP module with Nextion display:
Warning
Disconnect power supply when making connections!
Nextion PIN
ESP Pin
+5V (black)
5V
TX (red)
RX
RX (white)
TX
GND (yellow)
G
Important
Note the crossover RX TX pins
At this stage if you have done everything correctly after restarting tasmota the screen should sequentially show the information "WiFi OK", "MQTT OK"
Check the settings, mainly that the topics in the MQTT nodes match those you set in Tasmota, and that the MQTT configuration node is configured correctly.
At this stage, if you have done everything correctly, after deploy flow in NodeRed the display should show the demo application.
Casing
If you want to print the casing, use the project files included in the Casing folder.
1
2
Available Pages
0
1
2
3
4
5
6
7
8
9
Available Icons
50x50px (for use in header (PH.pic))
11
12
13
14
15
16
17
66
67
68
69
70x70px (for use as buttons images (P1.pic, P2.pic etc.)