speeduino/speeduino

Issues

• sequential fuel does not work in rover decoder

  #1240 opened 4 months ago by dwisnie2
  6

• 8 Squirts per engine cycle bug causing Zero duty cycle, lots of other problems

  #1253 opened 2 months ago by youngfg
  0

• MAP - non-Instantaneous sampling methods skip readings

  #1251 opened 2 months ago by adbancroft
  0

• MAP - Cycle Minimum & Event Average do not update EMAP

  #1250 opened 2 months ago by adbancroft
  0

• Suzuki K6A RPM code issue (minor bug)

  #1173 opened 2 months ago by adbancroft
  0

• Pin 14 is Always being pullup

  #1206 opened 2 months ago by FazxFi
  2

• Flex Sensor Settings not in function

  #1247 opened 2 months ago by Bolino08C
  4

• Support Wasted COP mode on Mega2560 6+3

  #1245 opened 3 months ago by ggurov
  2

• Crash/Misfire only with 202402 Firmware

  #1205 opened 2 months ago by zacharyneveu
  4

• Incorrect BMW Can broadcast Coolant value conversation.

  #1218 opened 6 months ago by Zazins
  10

• Staged injection: Different injector characteristics and timing possible?

  #1220 opened 5 months ago by Dominik335i
  1

• Test mode leaves ignition channels active when being stopped

  #1246 opened 2 months ago by ggurov
  4

• Data logging pin active when main data logging function is diabled

  #1244 opened 3 months ago by ggurov
  0

• Miata decoder - sequential does not run properly above 5000rpm

  #1243 opened 3 months ago by AlexE75
  2

• Secondary tables switching option for lesser instead of greater

  #1204 opened 8 months ago by joeclone
  3

• TunerStudio MS changing values randomly

  #1224 opened 5 months ago by Nikolai521
  6

• Reset control pin not working

  #1241 opened 3 months ago by Nikolai521
  0

• IAC Running Hot on Firmware 202305 and newer

  #1235 opened 4 months ago by dMartin1954
  2

• Issue with stm32f103c8t6 (Bluepill 128k) compiling with TIMERS error

  #1232 opened 4 months ago by ArtCodeZen
  3

• CAN RusEfi WBO not working together with BMW or VAG CAN broadcasting

  #1217 opened 4 months ago by Zazins
  11

• Fool-proof correction tables and other improvements

  #1226 opened 4 months ago by roko772
  4

• IDLE - new options

  #1186 opened 9 months ago by MercKlinika
  1

• multispark ata low rpm

  #1201 opened 8 months ago by PABLORDP
  3

• Stepper OL+CL control

  #1214 opened 6 months ago by ponzano
  7

• 202402 firmware VVT1 no reading and no duty aplied to solenoid.

  #1213 opened 6 months ago by h25r
  21

• Air Conditioning Control issue in ” closed + openloop STEPPER idle “mode

  #1166 opened 6 months ago by nuosu
  4

• Idle up allow signed value

  #1180 opened 10 months ago by turboedge
  0

• Taper on load axis on acc enrich

  #1210 opened 7 months ago by runesmdk
  1

• Does the Speeduino have Over the Air (OTA) updates?

  #1208 opened 7 months ago by kimanigitau01
  1

• Soft Launch ignition absolute timing is unsigned

  #1188 opened 9 months ago by noisymime
  1

• Dual injections on low RPM with Teensy 3.5 and 4.1

  #1181 opened 10 months ago by RempageR1
  12

• 2 stroke with Basic Distributor produces incorrect RPM reading

  #1192 opened 8 months ago by noisymime
  0

• Tacho sweep is not working with 202402 release

  #1195 opened 8 months ago by noisymime
  0

• Fuel Cut Rev Limiter

  #1196 opened 9 months ago by Tynashe28
  1

• Min/max allowable voltage value for O2 feedback.

  #1184 opened 9 months ago by Admanirv123
  4

• Suggestion: Remove current references to SAM D21 & E51

  #1147 opened 9 months ago by FoxUnpopuli
  6

• Sequential not working without cam signal.

  #1145 opened 9 months ago by TBAMax
  3

• Support for Free Pin Configuration on STM32 and Teensy 4.1 Boards in TunerStudio

  #1191 opened 9 months ago by bahram-azimbeyk
  0

• Bug: secondary spark table applies ignition corrections in multiply mode

  #1154 opened 9 months ago by adbancroft
  3

• Is primary injector pulse width calculation correct in calculateStaging(), when stagingMode is STAGING_MODE_AUTO?

  #1172 opened 9 months ago by ChrisNisbet01
  1

• Possible buffer overrun in comms_CAN.cpp?

  #1177 opened 10 months ago by adbancroft
  0

• OddSquirt not working on low RPM`s

  #1163 opened 10 months ago by RempageR1
  14

• PW unit test failing

  #1175 opened 10 months ago by adbancroft
  1

• STM32 LIBDIVIDE Division by 0 causes mcu hang

  #1162 opened 10 months ago by gdiciocco
  1

• Bug: analog sensor ISR conditional compilation uses wrong preprocessor symbol(s)

  #1156 opened a year ago by adbancroft
  5

• Rover decoder not set to use new ignition mode in speeduino.ini

  #1160 opened a year ago by mike501
  2

• Rotary ITB Setup with Direct Fire / Wrong controlled first spark plug

  #1159 opened a year ago by Rachus87
  0

• Bug: secondary fuel table doesn't set status bit in 2 cases

  #1153 opened a year ago by adbancroft
  1

• getAdvance1() & getAdvance2() return unsigned values

  #1152 opened a year ago by adbancroft
  1

• Deceleration enleanment

  #1151 opened a year ago by joeclone
  2