/ettus_research_usrp_b205mini_case

a printed case for the latest usrp b200mini and b205mini

Primary LanguageOpenSCADGNU General Public License v3.0GPL-3.0

3D printable Enclosure for the Ettus Research USRP B200mini and B205mini

This case is smaller and cheaper than the original case from Ettus. And you can modify it to show a logo or add other features. It was tested with an alumide-print from Shapeways and is now used for two USRPs.

URSP B200

tested print from Shapeways

  • polished metal plastic (alumide)
  • case top cost ~35€
  • case bottom costs ~31€
  • Result: very accurate print, included tolerances not fully needed

extra parts for assembly

  • 4x M3 12mm cylinder Screws (hexagon socket)
  • 4x M3 Nuts (self-locking)
  • 3x 3mm light pipes
  • Thermal Pads 1mm thick (Double Adhesive Heat Transfer Pads) for FPGA and ADC
  • conductive copper foil tape to shield the cages (optional)

Pictures

case explosion

case assembled C

case assembled A case assembled B

case inside A case inside B

case outside

todo

  • update link thingiverse
  • possible changes
    • reset hole could go 0.5mm to usb-port