Use MQTT and ESP8266/ESP32 module to control Mitsubishi HVAC unit. It use SwiCago librairies: https://github.com/SwiCago/HeatPump
Features:
- Initial config: WIFI AP mode and web portal
- Web interface for configuration, status and control, firmware upgrade
- Homeassistant autodiscovery and control with MQTT
- Control with MQTT
- Multilanguages
Screenshots:
How to use:
- Step 1: flash the sketch with flash size include SPIFFS option.
- Step 2: connect to device AP with name HVAC_XXXX (XXXX last 4 character MAC address)
- Step 3: You should be automatically redirected to the web portal or go to 192.168.1.1
- Step 4: set Wifi information, save & reboot. Fall back to AP mode if WiFi connection fails (AP password sets to default SSID name from step 2).
- Step 5: find the device IP with last 4 character MAC address in your router
- Step 6: (optional): Set MQTT information for use with Home Assistant
- Step 7: (optional): Set Login password to prevent unwanted access in SETUP->ADVANCE->Login Password
Nightly builds are available for select platforms via GitHub Actions. Go to the platformio workflow, select the latest build, then check the Artifacts section.
For nodered fans MQTT topic use cases
- topic/power/set OFF
- topic/mode/set AUTO HEAT COOL DRY FAN_ONLY OFF ON
- topic/temp/set 16-31
- topic/remote_temp/set also called "room_temp", the implementation defined in "HeatPump" seems not work in some models
- topic/fan/set 1-4 AUTO QUIET
- topic/vane/set 1-5 SWING AUTO
- topic/wideVane/set << < | > >>
- topic/settings
- topic/state
- topic/debug/packets
- topic/debug/packets/set on off
- topic/debug/logs
- topic/debug/logs/set on off
- topic/custom/send as example "fc 42 01 30 10 02 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 7b " see https://github.com/SwiCago/HeatPump/blob/master/src/HeatPump.h
- topic/system/set reboot
If you like my work and use it ;)
