Pinned Repositories
Arduino-UNO-28-Pins-PCB-Project
Dashboard-Polling
FirstRepository
pages-app
Sensor-Board-STM32
STM32-Sensor-Board-
A sensor board with a BMI088 IMU, and BM280 barometric pressure sensor, external flash memory and breakout pins for I2C, UART, and some of the timers and ADC pins. The processor being used on the board is an STM32F405RGT6 processor. All the Kicad project files including the schematics and the PCB files are included in this repository along with all the gerber and drill files and all the assembly files including the BOM and the position files.
STM32-Sensor-SD-GPS
This circuit board has an STM32F405RGT6 processor at its heart with an IMU and barometric pressure and temperature sensor, an SD card module for reading and writing data to SD cards, a GPS module with antenna for reading position data, and a CAN bus transceiver. There is also the typical hardware needed for interfacing with the processor such as crystal oscillator circuitry, a boot mode select switch, USB and power circuitry, and a debug interface.
STM32-USB-BUCK-Breakout-Board
This project includes the schematic and PCB files as well as the necessary Gerber and assembly files for a circuit board with an STM32F405RGT6 processor with some breakout pins for access to a set of the I2C and UART pins on the processor. This board also includes an SWD interface 02x05 pin for debugging and uploading firmware.
Tesla-Model-S-Simulink-Project
CSCI-665-project
peterg0313210's Repositories
peterg0313210/STM32-Sensor-Board-
A sensor board with a BMI088 IMU, and BM280 barometric pressure sensor, external flash memory and breakout pins for I2C, UART, and some of the timers and ADC pins. The processor being used on the board is an STM32F405RGT6 processor. All the Kicad project files including the schematics and the PCB files are included in this repository along with all the gerber and drill files and all the assembly files including the BOM and the position files.
peterg0313210/STM32-Sensor-SD-GPS
This circuit board has an STM32F405RGT6 processor at its heart with an IMU and barometric pressure and temperature sensor, an SD card module for reading and writing data to SD cards, a GPS module with antenna for reading position data, and a CAN bus transceiver. There is also the typical hardware needed for interfacing with the processor such as crystal oscillator circuitry, a boot mode select switch, USB and power circuitry, and a debug interface.
peterg0313210/Arduino-UNO-28-Pins-PCB-Project
peterg0313210/Dashboard-Polling
peterg0313210/FirstRepository
peterg0313210/pages-app
peterg0313210/Sensor-Board-STM32
peterg0313210/STM32-USB-BUCK-Breakout-Board
This project includes the schematic and PCB files as well as the necessary Gerber and assembly files for a circuit board with an STM32F405RGT6 processor with some breakout pins for access to a set of the I2C and UART pins on the processor. This board also includes an SWD interface 02x05 pin for debugging and uploading firmware.
peterg0313210/Tesla-Model-S-Simulink-Project