pimoroni/bme680-python

Issues

• ./install.sh fails in debian

  #52 opened 2 months ago by Ajb2k3
  0

• Using v2.0.0 with temperature_pressure_humidity.py unmodified example from repository

  #51 opened 4 months ago by baqwas
  1

• Altitude and sea level pressure

  #44 opened 4 years ago by TheOzarkWizard
  2

• Can this be used in micropython?

  #48 opened 2 years ago by 17lwinn
  3

• Getting the estimated CO2 in ppm

  #49 opened 2 years ago by GuylianStevens1
  0

• IOError: [Errno 121] Remote I/O error

  #19 opened 6 years ago by smallblackdog
  16

• Micropython support

  #7 opened 7 years ago by geoffklee
  28

• How do I force sleep mode?

  #46 opened 3 years ago by Arliom
  0

• Micropython bme.data.gas_resistance always exact same reading (-1.986394e+07 Ohms)

  #43 opened 4 years ago by jjcfrancisco
  0

• constants don't match Bosch-version

  #42 opened 4 years ago by bablokb
  0

• How can the heater be disabled?

  #38 opened 4 years ago by derekjc
  1

• gas same value

  #37 opened 4 years ago by jolugama
  0

• Error in get_sensor_data (after running for some time)

  #36 opened 4 years ago by aubourg
  0

• IOError: [Errno 121] Remote I/O error

  #10 opened 7 years ago by titusece
  4

• Add support for IAQ, eCO2 and bVOCe

  #34 opened 4 years ago by R-K-H
  1

• SPI instead of I2C?

  #27 opened 5 years ago by oxboxer
  3

• heat_stable goes to False, then intermittent Errno 121

  #30 opened 4 years ago by aluchuk
  0

• Temperature readings to high

  #11 opened 7 years ago by ayeks
  5

• Temperature offset and humidity issue

  #20 opened 6 years ago by giampiero7
  6

• Broken link in readme?

  #25 opened 5 years ago by christopherMills
  3

• can I make a pi with the bme680 hat act as a zigbee z-wave device ?

  #21 opened 5 years ago by adam-jones-net
  1

• chip id issue with BME680 Breakout

  #22 opened 5 years ago by StefanKreiling
  4

• Solution for "BME680 Not Found. Invalid CHIP ID: 0x-79"

  #23 opened 6 years ago by hongbo-miao
  0

• Invalid CHIP ID: 0x60

  #12 opened 7 years ago by djcaff263
  4

• Pressure reading too high (micropython)

  #3 opened 7 years ago by geoffklee
  28

• Extremely high/negative gas resistance readings

  #6 opened 7 years ago by davea
  5

• sensor never leaves FORCED_MODE

  #9 opened 7 years ago by kimbauters
  1