Eaton xComfort SHC integration for Home Assistance

This is Eaton xComfort smart home and Home Assistance integration custom component

Requirements :

It is recommended to set the language of your Smart Home Controller to english as some state descriptions are language dependent and this integration only supports the english values

Installation:

Use HACS to install the integration

Configuration

Please note only devices from one SHC zone will be added to HA. For zone 1 use hz_1, for 2 use hz_2, etc.

To find zone number log into SHC via web console using this address http://ip_address_of_your_integration/system/console/config, go to Configuration Status -> Home Devices and use search function to search for 'hz_'. Number following hz_ is the zone number.

You can create a root zone that will contain all your devices. Add this one in HA to get all devices!

Supported devices

The integration supports today:

Switch actuators
Light actuators
Shutter actuators
Scenes
Temperature sensor
Binary sensors
Radiator thermostats

The integration polls updates from xComfort SHC to Home Assistant with user defined frequency. Work on push based status updates is in progress.

xComfort to MQTT broker

For instant, push based updates from xComfort SHC to Home Assistant you can try AppDaemon based xcomfort2mqtt . This can be useful if you want to trigger Home Assistant automations from your xComfort devices

Help and new ideas

For help or question open an issue. For new ideas or comments open an discussion