AMConnect
This is a basic Arduino sketch to connect to a Huqsvarna Automower generation 2 robot mower. In it's current state it connects to the Autoower and sends the status, location and debug data to a mqtt server.
The code should be seen as a Proof of Concept code and not a real product.
Feel free to modify it as you see fit.
Hardware
Example hardware
The example hardware used for this project is based around a LOLIN32 developer module and a NEO-8M GPS.
As both the ESP32 and the NEO-8M module comes in alot of different forms and shapes, remember to match the settings in the configuration file with your hardware and wiring.
For my hardware, the wiring is as shown below. (Note: I have the GPS module upside down compared to the sketch, which makes all pins (except GND) line up with the pins on the LOLIN32 board.)
Pinout of the Automower header
The internal header to connect the hardware to is the white header, located just below the larger header for the main flat cable.
Pinout for the header
Connect to Automower
In this example, the hardware is connected to an Husqvarna Automower 230 ACX
