Request pre heating 5-10sec to prevent failsafe in cold climates
boobslappy opened this issue · 2 comments
boobslappy commented
I am requesting adding a 5-10 preheat to raise thermistors above threshold for those of us with our printing in cold areas. I’m having to use a blow dryer and don’t see why it couldn’t heat for a bit before checking thermistors. Could this feature be added? I’m on a prusa mini+. Thanks.
TickTock- commented
Yes. Please! (or lower the threshold)
JohnnyDeer commented
Hi @boobslappy this requirement should be in Prusa-Firmware-Buddy repository, please open it there according to the templates. I´m closing this one here.