Issues
- 3
Feature Request - config check
#57 opened by endurance1968 - 1
Question/Improvement: Battery Temperature
#60 opened by endurance1968 - 3
Compatible with python new version?
#59 opened by Rubens974 - 13
- 20
How to change CVL?
#23 opened by dersch81 - 1
DVCC Support not available anymore in 3.0.66
#58 opened by dersch81 - 4
- 19
CCL and DCL in new Capacity and Count modes does not take in to account "Allow to charge" and "Allow to discharge"
#47 opened by AlexdeKairos - 2
exclude service
#55 opened by rolandlueders - 2
Enhanced Load Balancing and Aggregation Strategy for Uneven Battery Charging Rates
#54 opened by ogurevich - 2
CCL and DCL to high
#52 opened by locke987 - 8
load to SOC reset
#48 opened by rolandlueders - 2
CCL to low?
#51 opened by endurance1968 - 3
Since v3.0.60 Again CCL = 0 and DCL =0 #40
#50 opened by Rubens974 - 9
Batt Charge Current is lower than CCL
#46 opened by locke987 - 4
all packs in Float at 54V, only BatteryAggregator is at 55.2V and dont reduce the CVL
#49 opened by superkrischi - 1
Cerbo GX changed DeviceID every reboot/update
#42 opened by Scheppo - 23
CVL drops and spikes, CCL and DCL swings
#37 opened by leiweke - 4
low battery
#39 opened by ondrom111 - 8
- 14
- 5
Lost batteries and shutdown
#38 opened by Albarge - 3
Feature request. Provide Battery information to victron CAN bus for other devices
#41 opened by AlexdeKairos - 7
Setting battery capacity issue
#43 opened by campervantime - 20
CCL = 0 and DCL =0
#40 opened by Rubens974 - 3
After limitation or CCL or DCL (new feature), CVL goes also to 0V. after resuming normal condition, CVL remains 0V
#36 opened by AlexdeKairos - 5
- 8
One battery goes to protection, closing charge and agregator sets CCL to 0a on all batteries.
#34 opened by AlexdeKairos - 12
- 2
Current vs. Voltage decimal points display
#32 opened by seamaster101 - 36
- 2
- 5
sudden change in CCL / DCL when loading
#30 opened by Micha854 - 11
Start battery aggregator after init of battery
#22 opened by dersch81 - 17
Battery aggregator gets stuck when SOC near 100%
#24 opened by dbachats - 6
CCL & DCL are not aggregated
#25 opened by johnboyi - 7
wrong value for InstalledCapacity
#29 opened by stixif - 6
Wrong voltage reading
#26 opened by 11011010 - 2
- 8
v3 error no Battery
#27 opened by stixif - 6
Restart BatteryAggregator
#21 opened by Dropdragger - 3
- 9
- 4
AB ver. 2.5 not working?
#19 opened by entropia1ac - 7
Shows wrong values for current
#15 opened by Dropdragger - 0
- 1
Clearer description for excluding services
#14 opened by Albarge - 14
- 18
- 2
Aggregator Current issue
#12 opened by nik-bok