DHT

A Kademlia DHT implementation for Go with a focus on performance and ease of use. It is not seek to conform to any existing standards or implementations.

implements a 160 bit keyspace
replication factor (K) of 20
wire protocol using flatbuffers
SO_REUSEPORT to concurrently handle requests on the same port
asynchronous api
supports values larger than MTU

Usage

In order to start a cluster of nodes, you will first need a bootstrap node that all other nodes can connect to first. To start a bootstrap node:

func main() {
    cfg := &dht.Config{
        ListenAddress: "127.0.0.1:9000", // udp address to bind to
        Listeners: 4,                    // number of socket listeners, defaults to GOMAXPROCS
        Timeout: time.Minute / 2         // request timeout, defaults to 1 minute
    }

    dht, err := dht.New(cfg)
    if err != nil {
        log.Fatal(err)
    }

    log.Println("bootstrap node started!")
}

Once a bootstrap node is up and runing, you can add other nodes to the network:

func main() {
    cfg := &dht.Config{
        ListenAddress: "127.0.0.1:9001", // udp address to bind to
        BootstrapAddresses: []string{
            "127.0.0.1:9000",
        },
        Listeners: 4,                    // number of socket listeners, defaults to GOMAXPROCS
        Timeout: time.Minute / 2         // request timeout, defaults to 1 minute
    }

    dht, err := dht.New(cfg)
    if err != nil {
        log.Fatal(err)
    }

    log.Println("node started!")
}

From any node you can then store values as follows:

func main() {
    ...

    // helper function to construct a sha1 hash that
    // will be used as the values key
    myKey := dht.Key("my-awesome-key")
    myValue := []byte("my-even-more-awesome-value")

    // stores a value for a given amount of time
    dht.Store(myKey, myValue, time.Hour, func(err error) {
        if err != nil {
            log.Fatal(err)
        }
        log.Printf("successfully stored key: %s -> %s", string(myKey), string(myValue))
    })
}

Once your value is stored, you can retreive it from the network as follows:

func main() {
    ...

    // finds the value. please note it is not safe to use the value outside
    // of the provided callback unless it is copied
    dht.Find(myKey, func(value []byte, err error) {
        if err != nil {
            log.Fatal(err)
        }
        log.Printf("successfully retrieved key: %s -> %s !\n", string(myKey), string(value))
    })
}

OS Tuning

For most linux distros, socket send and receive buffers are set very low. This will almost certainly result in large amounts of packet loss at higher throughput levels as these buffers get overrun.

How large these buffers will need to be will be dependent on your workload, so you should experiment to find the correct value.

You can temporarily increase the of the read and write buffers via sysctl:

# set the rmem and wmem buffers to ~128 MB each
$ sysctl -w net.core.rmem_max=536870912 && sysctl -w net.core.rmem_default=134217728 && sysctl -w net.core.wmem_max=536870912 && sysctl -w net.core.wmem_default=134217728

Development

To re-generate the flatbuffer definitions for the wire protocol:

$ make generate

To run tests:

$ go test -v -race

To run benchmarks:

$ go test -v -bench=.

purehyperbole/dht

DHT

Usage

OS Tuning

Development

Implemented

Future Improvements