Getting started with Pibrella
Do you have an add-on board for your Raspberry Pi called a Pibrella? Then what are you waiting for? Let's get programming it!
This project will teach you how to use Scratch GPIO and the Python Pibrella library in order to make use of your Pibrella.
Requirements
As well as a Raspberry Pi with an SD card loaded with Raspbian, you'll also need:
Hardware
- A Pibrella
Software
- Pibrella Python library
See more information on checking you have these packages installed, and how to install them, on the software installation page.
Worksheet & included files
You will need to follow the steps in the worksheet below.
Licence
Unless otherwise specified, everything in this repository is covered by the following licence:
Geeting Started with Pibrella by the Raspberry Pi Foundation is licensed under a Creative Commons Attribution 4.0 International Licence.
Based on a work at https://github.com/raspberrypilearning/pibrella-intro