/Octoprint_AnycubicVyper

A record of my Anycubic Vyper setup and my DIY Debian Bullseye based Octoprint setup. There doesn't seem to be much data out there regarding running Octoprint other than on a Raspberry Pi which are hard to get a hold of right now but there are many low cost/low power mini PCs out there around the same total cost. Hope this might help others on their 3d printing journey that end up going down a similar route I did

Primary LanguageShell

Supports amd64 Architecture

My Anycubic Vyper Setup

Check out the Wiki for details