/Adafruit_BLESniffer_Python

Python API for Adafruit's Bluefruit LE Sniffer

Primary LanguageCOtherNOASSERTION

Python API for Bluefruit LE Sniffer

This repository contains the Python API for Adafruit's Bluefruit LE Sniffer, and our easy to use API wrapper.

It has been tested on the following platforms using Python 2.7:

  • OSX 10.10
  • Windows 7 x64
  • Ubuntu 14.04

Related Links

Bluefruit LE Sniffer product page: https://www.adafruit.com/product/2269 Bluefruit LE Sniffer Learning Guide: https://learn.adafruit.com/introducing-the-adafruit-bluefruit-le-sniffer/introduction

Sniffer Python Wrapper

Running sniffer.py in this folder on the Bluefruit LE Friend Sniffer Edition board will cause the device to scan for Bluetooth LE devices in range, and log any data from the selected device to a libpcap file (in logs/capture.pcap) that can be opened in Wireshark.

The current example does not enable live streaming of data directly into Wireshark via named pipes since this would require a pre-compiled utility for each platform, but it should be possible to implement this on your platform if required.

Using sniffer.py

To use sniffer.py, simply specify the serial port where the sniffer can be found (ex. COM14 on Windows, /dev/tty.usbmodem1412311 on OS X, /dev/ttyACM0 or Linux, etc.):

python sniffer.py /dev/tty.usbmodem1412311

Note: You will need to run python with sudo on Linux to allow the log file to be created, so sudo python sniffer.py /dev/ttyACM0, etc..

This will create a new log file and start scanning for BLE devices, which should result in the following menu:

$ python sniffer.py /dev/tty.usbmodem1412311
Logging data to logs/capture.pcap
Connecting to sniffer on /dev/tty.usbmodem1412311
Scanning for BLE devices (5s) ...
Found 2 BLE devices:

  [1] "" (14:99:E2:05:29:CF, RSSI = -85)
  [2] "" (E7:0C:E1:BE:87:66, RSSI = -49)

Select a device to sniff, or '0' to scan again
> 

Simply select the device you wish to sniff, and it will start logging traffic from the specified device.

Type CTRL+C to stop sniffing and quit the application, closing the libpcap log file.

NOTE: You may need to remove the sniffer and re-insert it before starting a new session if you see any unusual error messages running sniffer.py.

Requirements

This Python script was written and tested on Python 2.7.6, and will require that both Python 2.7 and pySerial are installed on your system.