Enviro+

Designed for environmental monitoring, Enviro+ lets you measure air quality (pollutant gases and particulates), temperature, pressure, humidity, light, and noise level. Learn more - https://shop.pimoroni.com/products/enviro-plus

Installing

You're best using the "One-line" install method if you want all of the UART serial configuration for the PMS5003 particulate matter sensor to run automatically.

Note The code in this repository supports both the Enviro+ and Enviro Mini boards. The Enviro Mini board does not have the Gas sensor or the breakout for the PM sensor.

⚠️ This library now supports Python 3 only, Python 2 is EOL - https://www.python.org/doc/sunset-python-2/

One-line (Installs from GitHub)

curl -sSL https://get.pimoroni.com/enviroplus | bash

Note report issues with one-line installer here: https://github.com/pimoroni/get

Or... Install and configure dependencies from GitHub:

git clone https://github.com/pimoroni/enviroplus-python
cd enviroplus-python
sudo ./install.sh

Note Raspbian Lite users may first need to install git: sudo apt install git

Or... Install from PyPi and configure manually:

Run sudo python3 -m pip install enviroplus

Note this wont perform any of the required configuration changes on your Pi, you may additionally need to:

Enable i2c: raspi-config nonint do_i2c 0
Enable SPI: raspi-config nonint do_spi 0

And if you're using a PMS5003 sensor you will need to:

Enable serial: raspi-config nonint set_config_var enable_uart 1 /boot/config.txt
Disable serial terminal: sudo raspi-config nonint do_serial 1
Add dtoverlay=pi3-miniuart-bt to your /boot/config.txt

And install additional dependencies:

sudo apt install python3-numpy python3-smbus python3-pil python3-setuptools

Alternate Software & User Projects

enviro monitor - https://github.com/roscoe81/enviro-monitor
mqtt-all - https://github.com/robmarkcole/rpi-enviro-mqtt - now upstream: see examples/mqtt-all.py
adafruit_io.py - https://github.com/dedSyn4ps3/enviroplus-python/blob/master/examples/adafruit_io.py - uses Adafruit Blinka and BME280 libraries to publish to Adafruit IO
enviroplus_exporter - https://github.com/tijmenvandenbrink/enviroplus_exporter - Prometheus exporter (with added support for Luftdaten and InfluxDB Cloud)
homekit-enviroplus - https://github.com/sighmon/homekit-enviroplus - An Apple HomeKit accessory for the Pimoroni Enviro+
go-enviroplus - https://github.com/rubiojr/go-enviroplus - Go modules to read Enviro+ sensors

Help & Support

GPIO Pinout - https://pinout.xyz/pinout/enviro_plus
Support forums - http://forums.pimoroni.com/c/support
Discord - https://discord.gg/hr93ByC