/TicTacToe-Bot

Its a robot that plays tic tac toe.....

Primary LanguageC++MIT LicenseMIT

TicTacToe-Bot

Its a robot that plays tic tac toe.....

Build at your own risk, documentation is limited and the BOM below is NOT verified.

BOM

  • ~300g filament

  • 4x 625 bearings

  • 3x low profile gt2 20t 6mm drive pulleys

  • 200mm gt2 closed loop belt

  • 240mm gt2 closed loop belt

  • 11x M3x6 SHCS (BHCS probably better) bolt. 4x more for the electronics box lid.

  • 5x M3x16 SHCS bolts. Maybe get some M3x18 too just in case :D

  • 1x M5x16 SHCS bolt

  • 1x M5x40 SHCS bolt

  • 2x M5 Nut

  • 6x M3 Nut

  • A few M3 and M5 washers

  • some paper clips to connect servo to pen sleeve

  • Uniball 60151 pen, or any other that are a similar size to fit in the sleeve.

  • Some M2 bolt and nuts for raspberry pi camera mounting

  • 2x nema 17 steppers, <=40mm length

  • 1x mg90 servo

  • Raspberry pi zero w

  • Raspberry pi camera V1.X

  • Adafruit Feather M4 or similar

  • Stepper drivers, mine go one a custom pcb (files in repo) but you can solder your own or buy an OTS one

  • MAX98357 I2S Audio Amplifier Module

  • 8 ohm speaker

If you find any errors, please open an issue ticket!