romilly/quick2wire-python-api
Python API for controlling GPIO and I2C devices connected to the Raspberry Pi
PythonNOASSERTION
Issues
- 0
Is it work for RaspberryPi 4 B+
#74 opened by Minemetero - 0
Multiprocessing 2 sensors
#72 opened by lixinghe1999 - 0
- 4
Upload quick2wire-python-api to pypi.
#54 opened by OrangeTux - 0
gpio-admin: could not flush data to /sys/class/gpio/export: Device or resource busy
#67 opened by SephReed - 2
ImportError: No module named quick2wire.i2c
#52 opened by rudi48 - 1
- 0
Easier install method?
#63 opened by sphaero - 1
Update Pin Maps for the B+
#60 opened by skycoop - 0
Update Pin Maps for the B+
#61 opened by skycoop - 1
- 0
- 3
Revision-detection code is fragile
#43 opened by lurch - 0
State of output pins is not persistent
#55 opened by OrangeTux - 6
I2C does not work with Kernel 3.6 on Raspbian
#20 opened by npryce - 2
API supports both Python 2.7 and Python 3.2
#38 opened by npryce - 0
- 0
- 3
- 0
?? PYTHONPATH HELP NEEDED.
#48 opened - 0
pcf8591read example ignores address parameter
#47 opened by lurch - 1
invalid version in setup.py
#46 opened by DuncanRowland - 2
Occidentalis
#45 opened by smolesen - 0
Confusing error message when one tries to use a GPIO pin's fileno() when the pin has not been opened
#44 opened by npryce - 0
Add a close_all method to PinBank
#42 opened by npryce - 6
I2C writing and writing_bytes cannot seem to write more than 2 bytes of data at a time
#27 opened by davec2 - 1
SPI API Working in both Python 2.7 and Python 3.2
#39 opened by npryce - 1
Python version check
#34 opened by romilly - 0
SPI read buffer returns incorrect values
#33 opened by panbr907 - 1
- 1
unexport does not reset GPIO to initial state (only removes it from device list)
#17 opened by RandomDude4 - 0
sudo git pull
#23 opened by Radics - 3
GPIO pin mapping
#12 opened by jemgoss - 1
GPIO slower on Python3 than Python2
#19 opened by npryce - 3
Better GPIO Performance
#6 opened by dmcg - 6
- 10
No module named quick2wire.gpio
#15 opened by richardwillars - 1
Revision-detection code is wrong
#14 opened by lurch - 0
Setting SPI speed_hz seems to have no effect
#13 opened by evenwestvang - 2
- 1
Flush needed for writes
#10 opened by jemgoss - 3
Get output state
#8 opened by doraess - 3
I2C API truncates multi-byte reads
#5 opened by omerk - 0
- 2
- 1
Automatically unexport pins
#2 opened by odiroot - 2
OSError
#1 opened