+-------------+
| umon manual |
+-------------+
Operation
---------
When the monitor is started, it shows the PC the monitor will return to when
the quit command is used.
The prompt shows the current address for operations.
$08ff>
The current address under this prompt would be 0x08ff.
Commands
--------
General commands
q : Quit monitor mode
Monitoring commands
s(####):** : Show ** bytes starting at address #### or current address
w(####):** : Write byte ** at address ####, or current address
[0-9a-f] : Write byte at next address, increasing address
% : Show the debug output from the system
Execution commands
g : JSR2 to current address
g**** : JSR2 to given address
Stack operations
+W** : Push byte to WST
+R** : Push byte to RST
-W : Pop byte from WST
-R : Pop byte from RST