This repository is designed for Asrock Z390MPro4 to run Mojave 10.14.X/Catalina 10.15.X with no hassle. However, due to the time constraint, a step by step installation guide won't be covered in this guide. For more information (regarding installation), please check [Guide] Creating OSX Installer by Rehabman or installing Mojave 10.14.x with Etcher.
- Asrocks Z390M Pro4 (M.2 Key B * 2 + M.2 Key A+E * 1 + PCIe 3.0 x16 * 2)
- Intel i7-9700K (4.9GHz GHz OC, SMBIOS iMac19,1)
- Clover Bootloader (r5070) / OpenCore (0.5.3)
- Be quiet! Dark Rock Pro 4 (250w TDP, highly recommended)
- Kingston HyperX Fury Black 16GB 3200MHz DDR4 8G * 2 (3200MHz OC)
- WD Black 2018/PC SN720 NVMe 1T SSD
- Sapphire RX 580 Nitro+ 8G (BruceX 5K Apple Res 422 Master Exporting time 13s)
- Apple BCM94360CD Wi-Fi/Bluetooth + M.2 NGFF Key A+E Adapter
(Since I do not have any front USB, only the rear ones were enabled.)
- dGPU Hardware Accelaration (Final Cut Pro X, VideoProc, Compressor tested)
- AirDrop, Handoff (Apple Wi-Fi/Bluetooth required)
- iMessage (complete serial required)
- All USB3.1 Gen1/USB2.0 ports (few USB2.0 ports disabled)
- HDMI Audio (Sound Control is required to adjust volume)
- Onboard HD Audio (Realtek alc892, layout id: 1)
- USB 3.1 Gen2 (may require a USB3.1 Gen2 to PCIe Card, i.g. ASM1142 chip-based)
- USB Type-C has no video output (iGPU video output has been disabled to enable dGPU HW acceleration)
- BIOS Version P1.3 (Please do not upgrade! I was NOT able to boot up macOS with P4.X BIOSs and I had to disassemble the chip and flash P1.30 firmware.)
We don't recommend users to update the BIOS if their system is already running normally.
- Download
Hackintosh-BIOS.BINfrom the release page or Clone the whole repository (the file is under /BIOS_settings) and place it in anFAT32USB. - Enter
BIOS setup - direct to
OC Tweaker/Load USER UEFI Setup Profile from Disk - select
Hackintosh-BIOS.BINfrom your USB.
- Mojave 10.14.X Download (expired, will be fixed later on)
- Install macOS with etcher
- Download Mojave 10.14.X from App Store
- [Guide] Creating OSX Installer by Rehabman
- Add OpenCore Bootloader support
- NVRAM tested (motherboard CFG clock disabled)
- Remove WhateverGreen for 1.2GHz iGPU clock speed
- Upate kexts, BIOS settings
- Replace BCM94331CD with BCM94360CD for better AirDrop/Handoff support
- Update kexts/driver
- Catalina 10.15.1 compatiable
- Fixed onbard HD audio output
- Initial release