CYD-Klipper

An implementation of a wireless Klipper status display on an ESP32 + screen. Uses Moonraker to fetch data.

A simple and cheap solution to use a dedicated screen with Klipper, a 3d printing Firmware.

Required hardware

A ESP32-2432S028R is required to run this project. You can find out where to buy these on the "ESP32 Cheap Yellow Display" repository.

Features

View printer status
View print progress and print statistics
Start a print
(When the printer is idle) move the printer
(During a print) set fan speed, flow rate, speed and z offset
Manage temperature
Extrude/Retract filament
Execute predefined gcode macros
Toggle Moonraker power devices
OTA updates
Serial console over USB (115200 8n1, echo off, LF/LF)

Install

There is a web-based installer available. This is only supported on Chrome, Edge, Arc or Opera, and only on Desktop.

On initial install, all data should be wiped. On updates, data should be able to be kept without issues.

When there is an update available, a button in the settings will appear that can be pressed to update. If automatic updates are preferred, there is a toggle in the settings to automatically update. This will right after connecting to wifi update the screen.

Donate

If you found this project helpful, please consider a donation to my Ko-Fi. It would help out a lot in the development of this project, due to the need to buy the screens.

Thank you!