this code is written for Air soft gun target with arduino. I hope you will enjoy it!!
buy arduino UNO R3 starter kit amazon link
then download aruduino IDE link
git clone this repository and write target/target.ino to your arduino!!
install libraries by arduino IDE
Servo.h
IRremoteInt.h
IRremote
make board following below
s
change IR sensor signal which is depend on your remote controller(you can see it by arduino IDE)
connect your arduino to power
push power button in your controller
there are 2 modes!
mode1 : when you push button, servo moter will work and target will be ready mode2 : every 10 sec servo moter work automatically! mode3 : almost done not yet mode4 : coming soon...