/WM8960-Audio-HAT

The drivers of [WM8960 Audio HAT] for Raspberry Pi

Primary LanguageCGNU General Public License v3.0GPL-3.0

This is the installation script for the RASPIAUDIO ULTRA++ sound card for raspberry pi

More info here: https://raspiaudio.com/produit/ultra

THe complete installation guide is here: https://forum.raspiaudio.com/t/ultra-installation-guide/21

But in short you should: Clone the driver and install it with commands copy and paste each line in a terminal window:

git clone https://github.com/RASPIAUDIO/WM8960-Audio-HAT.git

cd WM8960-Audio-HAT

sudo ./install.sh

It could take a long time 5 minutes on a PI4, but 15mn or more on a Pi zero, so relax go get a drink then.

Before restarting do:

sudo nano /etc/pulse/default.pa

Then add the following lines:

load-module module-alsa-source device = hw: 0,0
load-module module-alsa-sink

Lastly Reboot using:

sudo reboot

Features:

Imput:

onboard microphone Left, Right Jack microphone Jack line input push button Outputs:

1.3w onboard stereo spakers (pre-soldered) 1.3w output stereo for external speakers Headphone jack stereo red led

Features:

65x30x15mm (compact Raspberry pi Zero format= Compatible with raspberry 4 (all version), Raspberry 3 (all versions), Zero (all versions) Standard Raspberry Pi 40PIN GPIO extension header, supports Raspberry Pi series boards Integrates WM8960 low power stereo CODEC, communicates via I2S interface Integrates dual high-quality MEMS silicon Mic, supports left & right double channels recording, nice sound quality Onboard standard 3.5mm earphone jack, play music via external earphone Onboard dual-channel speaker interface, directly drives speakers Supports sound effects such as stereo, 3D surrounding, etc. Headphone output (24bits)​ WM8960 input / output Mixer Hardware volume control 24 Bit I2S Dac​ 2×1.3W Stereo Amplifier for external speakers​ Stereo onbard speakers 2 Onboard microphones​ Stereo 3.5mm LINE jack input Stereo 3.5mm MICROPHONE jack input

CODEC: WM8960 Power supply: 5V Logic voltage: 3.3V Control interface: I2C Audio interface: I2S DAC signal-noise ratio: 98dB ADC signal-noise ratio: 94dB Earphone driver: 40mW (16Ω@3.3V) Speaker driver: 1.3W per channel (8Ω BTL) To use as a standalone speaker (expect the same quality and power as a high end phone). To use with as pair of old non amplified system from a backyard sell. Could be used for radio project, standalone art project,as a all in one audio card, project where you need to record live audio or play it using speakers or headphones.