signetlabdei/millicar

The vehicular-simple-one.cc and vehicular-simple-two.cc file question with paper(MilliCar - An ns-3 Module for mmWave NR V2X Networks)

Opened this issue · 4 comments

MOUmeiqi commented

Hi.Guys.
image

  1. above picture from the 'MilliCar - An ns-3 Module for mmWave NR V2X Networks' paper,I try to run the vehicular-simple-two.cc,but only "scenario.txt"in the results,I'd like to learn about how to get the result in the paper.(i.e Figure 5 SINR for a pair of vehicles in vehicular-simple-two.cc. 4×4 (8×8) indicates that both endpoints have antenna arrays with 4 (8) elements.)

  2. the second question is i already get result through runing the vehicular-simple-one.cc. (i.e it is refer to the figure 4 a) &b)) ,
    image
    image
    I get the data (simple-one-stats.txt )after running the code,I set the paraments in accordance with the paper, such as such as the initial distance between the vehicles, the bandwidth 100 MHz or 400 MHz. I want to konw that how to define paraments,like source rate and Average Latency, or say how to use formula to model in the this paper.
    I would be grateful if you could slove my confusion.
    Yours
    MOU Meiqi

MOUmeiqi commented

and i think My results deviate from the results of the paper,so , i want to konw why? ,i think the paraments is worst in my simulation, and the paper figure how to plot in the ns-3.
Yours
MOU Meiq

YinghuiZhang123 commented

Hi I am also working on the same paper and the codes. May I request you to share the results and how you have found the results to draw the graphs? Thanks.

MOUmeiqi commented
YinghuiZhang123 commented

Thanks a lot. Got your points. I am also doing the same