Source code for a 3D printed pogo pin holder for flashing various chips:
- TYWE5P ESP based chip: https://www.thingiverse.com/thing:4889239
- CB2S: https://www.thingiverse.com/thing:5905447
This is written using the SolidPython, so you will need to install the Python module to use it with the command:
pip install solidpython
Depending on your setup, you may need to just install it for your user account:
pip install --user solidpython
Once installed, generate the .scad files with:
python TYWE5P-pogopins.py
This will create a TYWE5P-pogopins.scad
file you can then use to generate a .STL in OpenSCAD.
Most of the dimensions and variables are at the top of the file. Run the file to build the OpenSCAD file, you can then open up in OpenSCAD.
Enjoy!